Mapei Ultracolor Plus Coloured Grout Moon White 103

Product Information

If cleaning is carried out a few hours after applying the grout, it may be necessary to leave it standing for longer (at least Before grouting, make sure the installation mortar or adhesive has set and that most of the moisture has evaporated. Mapei Kerapoxy Easy Design is not harmed by damp from the substrate, but the joints must not be wet when grouting. Obstructions e.g. steps, lifts, gravel paths and drives etc may mean the delivery will have to be made to the nearest available location to the delivery vehicle. The use of a Scotch-Brite abrasive pad instead of the traditional cellulose sponge for cleaning joints is recommended in

We reserve the right to impose a re delivery charge on all failed deliveries where customers are not present on the arranged delivery day. Parcel Deliveries where a high protection from the formation and proliferation of micro-organisms (such as fungus and mould) is required; Where required, add MapeGlitter or Mapecolor Metallic once the blend has been mixed, at a variable ratio depending on Mapei Ultracare Kerapoxy Cleaner for epoxy grout (special cleaning solution for epoxy grout) may also be used for the final cleaning cycle and may also be used to remove thin residues of grout up to several hours after application. In this case, the product must be left to react for longer (at least 15-20 minutes). The efficiency of Mapei Ultracare Kerapoxy Cleaner depends on the amount of residual resin and the amount of time gone by after application. Cleaning must be carried out while still “fresh” as described above.certified according to ISO 22196:2011 as a grouting mortar protected against the formation and proliferation of microorganisms.

Mapei Kerapoxy Easy Design is ideal for grouting ceramic tiles, glass mosaics and stone materials with grout joints measuring from 1 to 15 mm wide. It can also be used as an adhesive. Mapecolor Metallic is available in Moonlight (similar to platinum), Sahara (similar to gold), Shining (similarAfter grouting with Mapei Kerapoxy Easy Design, floor and wall coverings must be cleaned while the grout is still “fresh”. Wet the grouted surface and emulsify with an abrasive pad for cleaning joints (such as Scotch-Brite® or Kerakoll Cleaning Pad). Take care not to drag grout from the joint. Tiles/mosaics may also be cleaned with the same pad, but it must be more saturated with water. Any liquid which remains on the surface may be removed with a hard, cellulose sponge (such as a Mapei sponge or Kerakoll Cellulose Sponge). Replace the sponge when it is coated with too much resin, and also when finishing off the grouted joints. After grouting with Kerapoxy Easy Design, floor and wall coverings must be cleaned while the grout is still “fresh”. Mapei Ultracolor Plus does not contain Portland cement and must not be mixed with gypsum or other hydraulic binders; never add water to the mix once it has started to set.