About this deal
To change the measurement unit, hold the gear button (Figure A ) for three seconds to enter the units menu. Press the on button to confirm your reference location. Once confirmed, the current unit of measurement will be displayed, press the gear to change units and the on button to confirm. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Battery Safety
Once the current measurement is taken (the device is not in Continuous Measure mode), you can change the unit of measure from decimal ft (6.21 ft) to fractional ft (6'02"9/16), fractional ft to meters (1.894 m), meters to inches (74 9/16 in), or inches to decimal ft. Carefully read the Safety Instructions and Product Manual before using this product. The person responsible for the product must ensure that all users understand and adhere to these instructions. Position the tool at one end of the target and point the laser dot across the length. (Figure H ) shows where to position the tool if you are measuring from the top of the tool.) Total Tools reserve the right to terminate or amend the price guarantee policy at any time without notice. For Further Information
Terms & Conditions
Press and hold the gear button (Figure A ) for 3 seconds. The measurement reference location icon (Figure C ) will flash on the display window. Point the laser at the top of the tool laser (Figure A ) toward the wall or object whose distance you need to measure.
Position the tool at one end of the target and point the laser dot across the width. (Figure G shows where to position the tool if you are measuring from the top of the tool.) If INFO appears on the display window with a Code number, perform the corresponding Corrective Action. Code Position the tool at one end of the target and point the laser dot across the width. (Figure H ) shows where to position the tool if you are measuring from the top of the tool.)While the laser tool is in operation, be careful not to expose your eyes to the emitting laser beam (red light source). Exposure to a laser beam for an extended time period may be hazardous to your eyes. Do not look into the beam with optical aids. Press On button (Figure A ) to measure the distance from the tool to the wall or object. Refer to Setup LDM to change the reference location and / or unit of measurement. DO NOT mix old and new batteries. Replace all of them at the same time with new batteries of the same brand and type. Total Tools reserve the right to change or withdraw free delivery at any time. Estimated Delivery Timeframes Press the gear button (Figure A ) once to show the area icon (Figure B ) on the display window (Figure A ).